F5 101 Dumps Updated Performed Your Preparation
To successfully pass the Application Delivery Fundamentals exam, you must be well prepared. We have updated the F5 101 dumps to be the best preparation for your 101 exams. The new F5 101 dumps practice questions will give you a thorough understanding of the 101 exams and allow you to pass the F5 101 exam successfully.
The following questions and answers are from the latest 101 free dumps. It will help you understand the validity of the latest 101 dumps.
Question 1:
The incoming client IP address is 205.12.45.52. The last five connections have been sent to members C, D, A,B, B. The incoming client? IP address is 205.12.45.52. The last five connections have been sent to membersC, D, A, B, B. Given the virtual server and pool definitions and the statistics shown in the graphic, whichmember will be used for the next connection?
A. 10.10.20.1:80
B. 10.10.20.2:80
C. 10.10.20.3:80
D. 10.10.20.4:80
E. 10.10.20.5:80
Correct Answer: A
Question 2:
A site would like to ensure that a given web server\’s default page is being served correctly prior to sending itclient traffic. Theye assigned the default HTTP monitor to the pool. What would the member status be if it sentan unexpected response to the GET request?
A. The pool member would be marked offline (red).
B. The pool member would be marked online (green).
C. The pool member would be marked unknown (blue).
D. The pool member would alternate between red and green.
Correct Answer: B
Question 3:
A site needs to terminate client HTTPS traffic at the BIG-IP and forward that traffic unencrypted. Which two areprofile types that must be associated with such a virtual server? (Choose two.)
A. TCP
B. HTTP
C. HTTPS
D. ClientSSL
E. ServerSSL
Correct Answer: AD
Question 4:
A virtual server is defined using a source-address based persistence profile. The last five connections were A,B, C, A, C. Given the conditions shown in the graphic, if a client with IP address 205.12.45.52 opens aconnection to the virtual server, which member will be used for the connection?
A. 10.10.20.1:80
B. 10.10.20.2:80
C. 10.10.20.3:80
D. 10.10.20.4:80
E. 10.10.20.5:80
Correct Answer: B
Question 5:
What is the purpose of MAC masquerading?
A. to prevent ARP cache errors
B. to minimize ARP entries on routers
C. to minimize connection loss due to ARP cache refresh delays
D. to allow both BIG-IP devices to simultaneously use the same MAC address
Correct Answer: C
Question 6:
What is the purpose of provisioning?
A. Provisioning allows modules that are not licensed to be fully tested.
B. Provisioning allows modules that are licensed be granted appropriate resource levels.
C. Provisioning allows the administrator to activate modules in non-standard combinations.
D. Provisioning allows the administrator to see what modules are licensed, but no user action is ever required.
Correct Answer: B
Question 7:
Where is the load-balancing mode specified?
A. within the pool definition
B. within the node definition
C. within the virtual server definition
D. within the pool member definition
Correct Answer: A
Question 8:
Which statement accurately describes the difference between two load-balancing modes specified as”member” and “node”?
A. There is no difference; the two terms are referenced for backward compatibility purposes.
B. When the load-balancing choice references “node”, priority group activation is unavailable.
C. Load-balancing options referencing “nodes” are available only when the pool members are defined for the”any” port.
D. When the load-balancing choice references “node”, the addresses\’ parameters are used to make the loadbalancingchoice rather than the member\’sparameters.
Correct Answer: D
Question 9:
Which two statements describe differences between the active and standby systems? (Choose two.)
A. Monitors are performed only by the active system.
B. Fail-over triggers only cause changes on the active system.
C. Virtual server addresses are hosted only by the active system.
D. Configuration changes can only be made on the active system.
E. Floating self-IP addresses are hosted only by the active system.
Correct Answer: CE
Question 10:
Assuming other fail-over settings are at their default state, what would occur if the fail-over cable were to bedisconnected for five seconds and then reconnected?
A. As long as network communication is not lost, no change will occur.
B. Nothing. Fail-over due to loss of voltage will not occur if the voltage is lost for less than ten seconds.
C. When the cable is disconnected, both systems will become active. When the voltage is restored, unit twowill revert to standby mode.
D. When the cable is disconnected, both systems will become active. When the voltage is restored, bothsystems will maintain active mode.
Correct Answer: C
Question 11:
Which three files/data items are included in a BIG-IP UCS backup file? (Choose three.)
A. The BIG-IP administrative addresses.
B. The BIG-IP license.
C. The BIG-IP log files.
D. The BIG-IP default traps.
E. The BIG-IP host name.
Correct Answer: ABE
Question 12:
Which three parameters could be used to determine whether a connection request will havethe source address translated as the request is processed? (Choose three.)
A. The client\’s router\’s IP address.
B. The client\’s browser\’s preferred language.
C. The client\’s IP netmask.
D. The client\’s TCP port.
E. The client\’s IP address.
F. The client IP fragment offset.
Correct Answer: BDE
Question 13:
How many events can be referenced in a given iRule?
A. iRules are limited to one event, but a virtual server could be associated with multiple rules.
B. iRules can have multiple events.
C. Exactly one.
D. iRules can have up to event if one is client-side and one is server-side.
Correct Answer: B
Question 14:
Which statement concerning virtual servers is true?
A. Virtual servers can keep idle server connections open indefinitely.
B. Virtual servers can compress data between the BIG-IP and servers.
C. Virtual servers cannot perform load balancing without performing address translation.
D. Virtual servers can reuse connections between the BIG-IP and server for multiple HTTPGETs.
E. Virtual server processing always translates the virtual server address to the address of thechosen pool member.
Correct Answer: D
Question 15:
A GTM System would like to ensure that a given LTM System is reachable and iQuerycommunication is allowed prior to sending it client request. What would be the simplestmonitor template to use?
A. TCP
B. ICMP
C. HTTP
D. BIGIP
E. SNMP
Correct Answer: D