Dell Certifications DES-1241 Dumps Learning Materials Update

On By passitdump

How to prepare for the Dell Certifications DES-1241 exam? You can use the Passitdump DES-1241 dumps as study materials to prepare for the exam.

Our DES-1241 dumps are specifically designed to prepare for the Dell DES-1241 exam, contain 98 real questions, and proficient practice, and you will be able to pass the Specialist – Platform Engineer, PowerStore exam.

Check the following DES-1241 free dumps or download DES-1241 dumps here.

Question 1:

DRAG DROP

When connecting a PowerStore base enclosure to 2 expansion enclosures, match the base SAS ports in column A to their corresponding expansion LCC ports in column B.

Select and Place:

Correct Answer:

Reference: https://www.dell.com/support/manuals/pk/en/pkbsd1/powerstore-1000/pwrstr-isg/cable-the-base-enclosure-to-the-expansion-enclosure?guid=guid-d68d049f-2b77-489f-b1ab-553f4f3de8aaandlang=en-us

Question 2:

DRAG DROP

Match the correct non-disruptive upgrade process step (answer column) with the correct sub-step (match column).

Select and Place:

Correct Answer:

Question 3:

DRAG DROP

Order the steps to prepare for an NDU process.

Select and Place:

Correct Answer:

Question 4:

DRAG DROP

Match the base enclosure SAS ports in column A to their corresponding expansion LCC ports in column B; when connecting a PowerStore base enclosure to a single expansion enclosure.

Select and Place:

Correct Answer:

Question 5:

DRAG DROP

Order the NDU operational steps.

Select and Place:

Correct Answer:

Question 6:

What describes Dell EMC PowerStore X front-end cabling?

A. Uses internal VMware virtual switching and does not require a management network

B. Storage and management use the same LACP bonded cable connection

C. Uses VLTi data switch interconnectivity to support vMotion networks

D. Management and discovery use the same cables and connections as storage

Correct Answer: C

Question 7:

Through which network do external hosts connect to the cluster for data access?

A. Management

B. ICM

C. ICD

D. Storage

Correct Answer: D

Reference: https://topics-cdn.dell.com/pdf/pwrstr-hcg_en-us.pdf

Question 8:

A Storage Administrator is adding an appliance into an existing Dell EMC PowerStore T cluster.

What is different about the management network configuration for the new appliance compared to configuring an initial appliance for the cluster?

A. All the needed management IP addresses for the new appliance must be pre-configured on the cluster

B. Additional appliance does not require a cluster management IP address

C. Additional appliance inherits all its management IPs from the existing appliance

D. All the needed management IP addresses for the new appliance are auto-generated by the cluster

Correct Answer: D

Question 9:

What describes the power requirements for Dell EMC PowerStore?

A. Lower model numbered systems require less AC line current than higher model numbered systems

B. T models require less total power than X models

C. X models require less total power than T models

D. Lower model numbered systems require less input voltage (VAC) than higher model numbered systems

Correct Answer: A

Reference: https://www.dell.com/support/manuals/pk/en/pkbsd1/powerstore/pwrstr-plang/power-requirements?guid=guid-21e142df-e22c-4bbc-8978-7c6124753654andlang=en-us

Question 10:

What is the last step when adding a drive to a Dell EMC PowerStore system?

A. Verify the new drive is seen

B. Add the drive to the pool

C. Backup the keystore

D. Zero the drive

Correct Answer: A

Reference: https://www.dell.com/support/manuals/pk/en/pkbsd1/powerstore-9000t/pwrstr-isg/install-a-25-drive?guid=guid-bddae51e-a561-4e84-bc0a-c2e99a43f033andlang=en-us

Question 11:

Refer to the exhibit.

A Storage Administrator is troubleshooting a Dell EMC PowerStore T hardware issue. They observe that the base enclosure LED circled is blue. What does this indicate?

A. Base enclosure hardware is operating normally

B. Base enclosure has a component hardware fault

C. Cluster has only a single appliance

D. Appliance has a node in service mode

Correct Answer: A

Reference: https://www.dell.com/support/manuals/pk/en/pkbsd1/powerstore-9000t/pwrstr-isg/embedded-module-leds?guid=guid-bc07892c-75cf-43b6-8f17-8a4c49001aebandlang=en-us

Question 12:

A Storage Administrator needs to connect through SSH to run svc commands. How is the SSH session configured?

A. Appliance IP address using port 22

B. NAS server IP address using port 26

C. NAS server IP address using port 22

D. Appliance IP address using port 26

Correct Answer: C

Question 13:

Which port is used to SSH from one Dell EMC PowerStore appliance to another?

A. 22

B. 26

C. 443

D. 21

Correct Answer: A

Reference: https://topics-cdn.dell.com/pdf/pwrstr-scg_en-us.pdf

Question 14:

Refer to the exhibit.

What is the result of the network configuration shown for a Dell EMC PowerStore T?

A. Interfaces are configured for remote replication traffic

B. Interfaces are configured for PowerStore discovery traffic

C. Ports 1/1/55 and 1/1/56 are added to a new LACP domain

D. Ports 1/1/55 and 1/1/56 are added to the VLTi domain

Correct Answer: B

Question 15:

How is a defective DIMM displayed in Dell EMC PowerStore Manager?

A. Orange with an empty state

B. Blue with a faulted state

C. Orange with a faulted state

D. Blue with an empty state

Correct Answer: C